Fusion project block. These handcrafted project blanks feature stabilized burl fused with acrylic. Each unique blank is handcrafted in Guelph ON. Blocks measure minimum 2" x 2" x 5-1/2".
- For best results and to avoid blowouts, you must use razor sharp tools (we recommend the Pen Master ACCU-CUT round chisel) and take very light cuts. Ensure your brass tube is thoroughly covered in glue when gluing it into the blank. If any part of the brass tube is not well covered with glue, that is the spot that will let go as you near the end of turning.
- We strongly recommend that you paint the outside of the brass pen tube in your kit and the inside of the hole you drill in the blank before gluing the brass tube into the blank. Otherwise your brass tube may show through. The colour you choose to paint your blank can change the appearance of your finished blank. We recommend a durable paint like enamel that can be purchased at most hobby stores.
- We recommend finishing Fusion blanks like you would a wooden pen blank. If you use Micro Mesh, we recommend wet sanding to avoid fine scratches in the acrylic.
- It is not uncommon to find the occasional small void in the blank while turning. This is not considered a defect; a small void can be easily filled in with a small amount of thick CA glue.
NOTE: The blanks in the photograph are representative only and the blanks you receive may differ slightly from the image. Burl is a natural product and variability in colour and pattern is natural and to be expected. These blanks are handcrafted and carefully inspected to ensure high quality. We do NOT replace blanks that become damaged during any part of the cutting, drillng, trimming, turning, finishing or assembly process.
Price per blank in Canadian dollars.